The manual crawl function can create a diagram from the record of the operation of the target site on the remote browser, but depending on how the site is created, the diagram may fail to be reflected.
In such cases, one of the following methods may solve the problem.
|
１．How to resolve the problem by setting the scan configuration item |
|
Attention
|
１．How to resolve the problem by setting the scan configuration item.
For functions that use the Shadow DOM, setting ‘Shadow DOM support for manual crawl’ to ‘Enabled’ in the scan settings may resolve the issue.
See the FAQ article below for an explanation of the ‘Shadow DOM support for manual crawl’ configuration item.
https://www.aeyescan.help/hc/en-us/articles/37802226458009
２．How to resolve this by adding Wait values
If the Page is taking a long time to load, this may cause the diagram to fail to reflect.
In this case, it may be possible to solve the problem by manually adding a Wait value.
See the FAQ article below for instructions on adding Wait values.
https://www.aeyescan.help/hc/en-us/articles/37802233294361
３．How to use the remote browser's operation editing function to respond
If the aforementioned method does not resolve the problem, it may be possible to resolve the operation that is not reflected in the diagram by specifying Xpath in the remote browser's operation editing function.
See the FAQ article below for specific instructions.
https://www.aeyescan.help/hc/en-us/articles/37802241275161